In the past, if exercise and dieting couldn’t get rid of stubborn fat bulges, many patients prefered liposuction, an invasive surgical procedure. Or, they looked to radio frequency devices or infrared technology, however, these devices provided limited improvement. With advancements in technology, patients can now reduce unwanted fat bulges and enjoy permanent decrease in fat cells during a non-invasive, non-surgical method called CoolSculpting that provides dramatic results.
Created by ZELTIQ Aesthetics, Inc., CoolSculpting can reduce areas which can be difficult to reach with exercise and dieting: love handles, lower belly fat rolls, upper belly fat, muffin top, under bra fat and back fat. It’s an incredibly effective technique that increases the contour in the body.
How is this possible? The FDA-cleared CoolSculpting works via a revolutionary technology called cryolipolysis. During cryolipolysis, literally meaning “cold induced fat destruction,” fat cells are cooled to a temperature that causes these to be eliminated. The procedure is safe: the temperature necessary to destroy fat cells is higher than what would affect skin, muscle and nerves. With CoolSculpting, there is no injury to the nearby structures.
Throughout the procedure, the physician applies a skin protecting gel pad for the skin, and a CoolSculpting applicator is positioned within the desired treatment area. The device draws the fat bulge in, and cools down the fat to induce cryolipolysis, continuously monitoring the temperature and adjusting it as a needed.
Unlike liposuction, where the fat cells are suctioned from the body, the CoolSculpting treatment causes the body to naturally remove the fat cells through the lymphatic drainage system. The cells are then slowly excreted by the body over a duration of the next several months.
With CoolSculpting, therapy for each fat bulge normally takes 60 minutes to perform. Love handles may take 2 to 4 hours of treatment; the lower abdomen typically takes about 1 hour using a special larger applicator. However, each case is different the patient/physician should discuss this before the procedure.
Instead of liposuction, no anesthesia is necessary for CoolSculpting. Throughout the procedure, patients can even use their telephone or laptop, read a book or watch a movie. The only discomfort patients may feel while undergoing CoolSculpting is a sensation of somebody pinching or squeezing the fat if the device is first applied to the skin. This usually goes away within the first 5 minutes of the procedure.
CoolSculpting can be done inside the convenience of a physician’s office. Patients go home right after the procedure and can resume regular activities; many have already been known to work out or do yoga exactly the same day. There may be some mild discomfort in the region of treatment; numbness is usually present afterward and can take several weeks to resolve. Extra Strength Tylenol® can be used but it’s advised to avoid taking anti-inflammatory agents for your first two months right after the procedure.
Many patients start noticing results the moment 3 weeks right after the CoolSculpting procedure. A lot of the results will likely be seen at about two months after CoolSculpting is conducted; improvement may continue after three months.
Generally, your skin layer is elastic enough to contract following the treatment. However, it’s important to know that if loose skin is the main cause of the bulge, then CoolSculpting alone will never treat the condition – a surgical procedure such as a tummy tuck may be needed.
Many patients ask if you have a requirement to begin a new diet or exercise routine after CoolSculpting. There fkkloi not. It’s recommended that patients retain the same program they did prior to the procedure to keep their weight.
Most people need only one CoolSculpting treatment; however, repeat treatments can be done after three months if additional lowering of the fat bulges is desired. Coolsculpting Before and After Photos show that the results of coolsculpting are impressive and undeniable.